Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×

ATK Audiotek Chooses Powersoft Amplifiers for American Music Awards

Loudspeaker System for Top U.S. Awards Show is Driven Exclusively by Powersoft K10 DSP+AESOP Amplifiers and Armonia DSP Software

FOH Music Mixer Jim Ebdon mixes for rehearsals at the 43rd annual AMA Awards.

At the 43rd annual American Music Awards, held at Microsoft Theater in downtown Los Angeles on November 22, ATK Audiotek—which has been providing audio services for the AMA Awards for 25 years—handled sound services that included equipment specification, set up, front-of-house and monitor engineering. “For all the large shows we deploy, we depend on Powersoft for the main P.A., monitors and subs,” says engineer Sean Prickett of ATK Audiotek.

With approximately 7,000 people in attendance, the program was broadcast to more than 10 million viewers across the U.S. and featured performances by musical artists including Coldplay, The Weeknd, Demi Lovato and many others. The show was highlighted with a moving performance of “Hymne à l’amour” by Celine Dion, which eulogized victims of the recent terrorist attacks in Paris.

Michael Parker, B Stage monitor mixer

The AMA presented awards to artists including One Direction, Ed Sheeran, Rihanna, Fall Out Boy, and others. Country artist Sam Hunt was recognized as New Artist of the Year, while Taylor Swift scooped up nominations in six categories. The night was hosted by Jennifer Lopez and featured A-list presenters including Harrison Ford, Prince, and Jenny McCarthy.

Audio for the entire awards show performance was driven by over 100 Powersoft K10 DSP+AESOP amplifiers, located in racks situated throughout the facility. 

“There is dialog [during the awards show], but it is standard for us to have to go A Stage to B stage after a [voice-over] right into another performance,” says Prickett. “It was certainly a case of ‘all hands on deck’ for everyone in the audio department. We have so many amps out there and with Powersoft, I was not concerned about reliability at all.” 

“[AMA] is considered one of the top three music shows in the country, so there is a certain amount of prestige when the artists come in and they have certain expectations,” says Mikael Stewart, VP Special Events, ATK Audiotek. “We are doing a lot of show in a relatively short amount of time, so everything has to go in, work right away, and be flexible.”

Having done many shows in the Microsoft Theater, formerly Nokia Theatre L.A. Live, ATK has established its audio system there. “Our system for Microsoft Theater consists primarily of four main hang arrays, four delay arrays, three balcony hung delays as well as under balconies and two different versions of front fills for FOH,” explains Prickett. “Typically, for these awards shows, we do a split up distributed drive system, unlike what we might do for typical touring situations.”

For the main P.A. and main delays, ATK specified JBL VerTec 4089 line arrays and 4886 balcony delays, all powered by Powersoft K10s. “We deploy a distributed system to give us more flexible set up for music and dialog, and it means we do not have to drive the P.A. as hard because there are many zones to create a nice even coverage pattern throughout the whole house,” says Prickett.

ATK Audiotek’s racks of Powersoft K10 DSP + AESOPs at the 2015 AMA Awards

ATK relies on Powersoft’s Armonia software to catalog and recall key DSP settings so the production team doesn’t have to start from scratch when it comes to set up and room-tuning. “These venues are very much the same, and the show hasn’t really changed its physical structure over the last five years,” says Stewart. “We just load the presets from the Armonia software, which gives us a really good starting point so we don’t have to spend hours re-tuning the room.”

“We use Powersoft Armonia exclusively for our DSP, and there is no other system controller in front of it,” Prickett adds. “We rely very heavily on this to tune the system, as well as facilitate EQ and level changes. The preset capability is a key feature for us, since time is always of the essence in these shows.

“The main reason we use K10 DSP+AESOPs at ATK Audiotek is because they allow us to operate in a reduced physical footprint, which is essential in the rack world when it comes to amplifiers,” says Prickett. “Since each K10 takes up just 1U, we are able to have a spare amplifier at each location without tying up a prohibitive amount of rackspace. So in case one of the signals goes away, we have a backup at every single amplifier. 

“There were absolutely no issues with any of the 100 amplifiers on our network,” concludes Prickett. “Everything went smoothly and without incident: This is the kind of performance we rely on.”

Find information about the Powersoft K Series.

Close